![]() Inet 172.16.125.1 netmask 0xffffff00 broadcast 172.16.125.255Īfter that, I started to use VMX Extras to modify the VMX file. NAT networking on vmnet8 is Tokamak 2.0.0: Installer completed vmnet8 is a NAT network on private subnet Tokamak 2.0.0: Extended network scripting - Dave Parsons vmnet1 is a host-only network on private subnet 172.16.125.0.ĭo you wish to configure another host-only network? Tokamak 2.0.0: Display settings ![]() The following host-only networks have been defined: vmnet8 is a NAT network on private subnet 172.16.184.0.ĭo you wish to configure another NAT network? (yes/no)Ĭonfiguring a host-only network for vmnet1. The following NAT networks have been defined: Wizard or the editor? (wizard/editor/help)ĭo you want this program to probe for an unused private subnet? (yes/no/help) tokamak.sh Tokamak 2.0.0: Installer Tokamak 2.0.0: Stop daemons and Tokamak 2.0.0: Create backup Tokamak 2.0.0: Save original Tokamak 2.0.0: Set boot scriptĭo you want networking for your virtual machines? (yes/no/help) tokamak.sh -install" again.īMBP:tokamak200 boyce$ sudo. However, as Dave has ever mentioned that it is not good to delete vmnet1 and vmnet8, so I run "sudo. vmnet3 is bridged to Tokamak 2.0.0: Extended network scripting - Dave Parsonsīridged networking on vmnet0 using en0 is runningīridged networking on vmnet2 using en1 is runningīridged networking on vmnet3 using en2 is running The following virtual networks have been defined: Removing a host-only network for Tokamak 2.0.0: Display settings In that directory that this program did not create, it will not be removed.ĭo you want to be able to use host-only networking in your virtual machines? Support/VMware Fusion/vmnet8/, and was about to remove it. ![]() This program previously created the directory /Library/Application Which one do you want to bridge to vmnet2? en1Ĭonfiguring a bridged network for vmnet3.Īll your ethernet interfaces are already bridged.ĭo you want to be able to use NAT networking in your virtual machines? (yes/no) Your computer has multiple ethernet network interfaces available: en2, en1. The following bridged networks have been defined:ĭo you wish to configure another bridged network? (yes/no) yĬonfiguring a bridged network for vmnet2. Wizard or the editor? (wizard/editor/help) w Would you prefer to modify your existing networking configuration using the Would you like to skip networking setup and keep your old settings as they are?ĭo you want networking for your virtual machines? (yes/no/help) y Here below is the terminal output:īMBP:tokamak200 boyce$ sudo. tokamak.sh -modify", which is something not documented, to add additional vmnet. After a lot of study of Tokamak.pdf" and trial, I discovered that I have to use "wizard" when I execute "sudo.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |